CBWLZ - JB-4 SOLUTION A, 0226A
- MSDS: CBWLZ
- Manufacturer: POLYSCIENCES INC
- Product Name: JB-4 SOLUTION A, 0226A
- National Stock Number: 6810-00N067087
Product Identification
Product ID:JB-4 SOLUTION A, 0226A
MSDS Date:03/04/1988
FSC:6810
NIIN:00N067087
Kit Part:Y
MSDS Number: CBWLZ
Responsible Party
WARRINGTON, PA 18976
US
Emergency Phone: 215-343-6484
Info Phone: 215-343-6484
Cage: 9C365
Contractor
Telephone: 215-313-6484
Cage: 9C365
Ingredients
ACRYLIC MONOMER
Fraction By Weight: >75%
OSHA PEL N/K
ACGIH TLV: N/K
ETHANOL, 2-BUTOXY-; (2-BUTOXYETHANOL)
CAS: 111-76-2
RTECS: KJ8575000
Fraction By Weight: <25%
OSHA PEL S, 50 PPM
ACGIH TLV: S, 25 PPM
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:MAY IRRITATE THE EYES, NOSE,
THROAT, MOUTH AND THE TISSUES OF THE SKIN. ANIMAL STUDIES HAVE
CLEARLY DEMONSTRATED DOSE-RELATED ADVERSE EFTS ON THE CNS,
HEMATOPOIETIC TISS, BLOOD, KIDNEYS & LIVER ASSOC W/ADMIN OF
ETHYLENE GLYCOL MONOBUTYL ETHER (EGBE). (EXTRACTED FROM DHHS
(NIOSH) PUB NO. 90-118) .
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:SKIN:WASH AFFECTED AREA WITH COPIOUS AMOUNTS OF WATER.
EYE:FLUSH WITH WATER FOR @ LEAST 15 MINUTES. INHAL:REMOVE TO FRESH
AIR; GIVE OXYGEN OR ARTIFICIAL RESPIRATION, AS NEEDED. INGEST:GET
PROMPT MEDIC AL TREATMENT. SEEK MEDICAL TREATMENT IFDISCOMFORT
PERSISTS.
Fire Fighting
Extinguishing Media:WATER, CARBON DIOXIDE, DRY CHEMICAL POWDER, FOAM.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:MATERIAL IS A MODERATE FIRE HAZARD.
Accidental Release
Spill Release Procedures:ABSORB SPILL ON SAND OR VERMICULITE, SCOOP UP
AND HOLD FOR DISPOSAL. WEAR NIOSH/MSHA APPRVD SCBA, RUBBER BOOTS
AND RUBBER GLOVES.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE MATERIAL IN A COOL, DRY PLACE.
KEEP STORAGE CONTAINER TIGHTLY CLOSED. DO NOT GET MATERIAL ON SKIN
OR CLOTHING OR IN THE EYES.
Other Precautions:WASH CONTAMINATED CLOTHING BEFORE REUSE.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:LOCAL VENTILATION REQUIRED.
Protective Gloves:RUBBER GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EMERGENCY EYE WASH & DELUGE
SHOWER .
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Chemical Properties
Vapor Density:HVR/AIR
Evaporation Rate & Reference:NOT KNOWN
Solubility in Water:SLIGHTLY SOLUBLE
Appearance and Odor:CLEAR LIQUID; ESTER TYPE ODOR.
Percent Volatiles by Volume:100
Stability
Stability Indicator/Materials to Avoid:YES
POLYMERIZING AGENTS, HEAT.
Stability Condition to Avoid:HEAT AND OXIDIZERS.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE.
Conditions to Avoid Polymerization:MAY POLYMERIZE ON EXPOSURE TO LIGHT.
Disposal
Waste Disposal Methods:MIX WASTE WITH A COMBUSTIBLE CARRIER AND BURN IN
A SUITABLY EQUIPPED CHEMICAL INCINERATOR. DISPOSAL MUST COMPLY WITH
FEDERAL, STATE AND LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.